Serving Fulton, Minneapolis

Mold removal in Fulton, Minneapolis

Mold remediation in Fulton and Lynnhurst homes in SW Minneapolis. IICRC certified, careful of finishes, insurance-documented.

24/7 emergency response
IICRC certified team
Licensed & fully insured
5-star local reviews

Call Now: (612) 555-0142 Get Free Inspection →

IICRC Certified

Licensed & Insured

24/7 Emergency Service

Free Inspection

Fulton, Minneapolis

Fulton mold calls are often small, but they need careful work because the homes are finished well. Around Beard, Chowen, Drew, and Xerxes, we see 1930s to 1950s Tudor and Colonial-Revival houses with plaster walls, tight basement rooms, built-ins, and older framing that does not like excess moisture.

The common pattern is not a flooded basement. It is a finished lower level running 60 to 70 percent humidity for months, or an attic gable with staining after ice dams. For mold removal Fulton Minneapolis homeowners can start with a free inspection, moisture readings, and a clear scope before anything gets opened.

Finished Fulton basements often hide a humidity problem

Many Fulton basements were finished after the house was built, often with carpet, paneling, drywall, or built-in cabinets added over older concrete and block. The space may look clean, but if there is no dehumidifier tied to a drain, summer humidity can stay high behind baseboards and along exterior walls.

We check the room first, then the materials. That means moisture readings at the bottom plates, under carpet edges, behind furniture, and near foundation corners. In homes near 50th and France or along France Avenue, we often find small mold growth behind storage walls or on the back side of drywall where cool masonry meets damp indoor air.

Removal may be limited to a few feet of baseboard and drywall. If the framing is sound, we clean it, treat it, dry the area, and talk through dehumidifier sizing. A 40 to 50 pint unit with a drain hose can change the whole basement.

Ice dams leave attic mold at gables and dormers

Fulton roofs have a lot of character, especially on Tudors with steep slopes, small dormers, and tight attic pockets. Those roof lines can trap snow. When attic heat melts that snow and it refreezes at the eaves, water can back up under shingles and wet the roof deck.

The stains are often found at gable ends, dormer cheeks, or near the lower roof edge. Homeowners may notice a faint attic smell, dark roof sheathing, or a small ceiling mark in an upstairs bedroom. We look for wet insulation, blocked soffit vents, bath fans that dump into the attic, and air leaks around can lights or old chimney chases.

For attic mold, we contain the work area, protect the access path, remove loose growth, clean the sheathing, and address the moisture cause. If the ice dam issue stays, the mold can return on the next bad winter.

Small-scope removal for well-kept, high-value homes

Fulton homeowners tend to catch stains early. That helps. A small area behind a basement cabinet or a patch of attic sheathing should not turn into a large demolition job unless the moisture readings and material damage call for it.

We set containment based on the room, not a template. In a finished basement, that may mean floor protection, plastic at a doorway, negative air, and careful cuts along trim so good millwork can stay. In an attic, it may mean a sealed work path from the hatch, HEPA air control, and bagging debris before it comes through the house.

The tradeoff is time versus disruption. Careful work can take longer than ripping out a wide section, but it protects plaster, tile, built-ins, and painted trim. After removal, we give plain notes on what caused the growth and what should change next.

Services

Mold problems we solve in Minneapolis

From a single moldy bathroom wall to whole-basement remediation, every job handled by certified, insured technicians.

Mold Inspection & Testing

Air and surface testing with certified lab analysis.

Learn more about Mold Inspection & Testing

Mold Removal & Remediation

Full containment, removal, and HEPA air scrubbing.

Learn more about Mold Removal & Remediation

Black Mold Removal

Safe removal of toxic Stachybotrys (black mold).

Learn more about Black Mold Removal

Basement Mold Removal

The #1 mold problem in Minneapolis homes, solved.

Learn more about Basement Mold Removal

Attic Mold Removal

Roof leak and ventilation mold treated and sealed.

Learn more about Attic Mold Removal

Real Minneapolis Jobs

Before & after

Local homes, real results. Every job documented with photos, lab reports, and clearance testing.

Basement drywall, South Minneapolis
Heavy mold removed and surface restored after spring flooding.

Attic sheathing, Edina
Ventilation issue corrected, sheathing treated and sealed.

5-Star Reviews

Trusted across the Twin Cities

4.9from 380+ local homeowners

"Called at 9 PM after finding black mold in our basement. They were here the next morning, walked us through everything, and the air smelled fresh again within days."

"Honest pricing and no scare tactics. Other companies wanted $8k, these guys did the job properly for less than half that and showed me the lab results."

"We had attic mold from an old roof leak. The team handled insurance paperwork and the workmanship warranty gave us real peace of mind selling the house."

Service Area

Serving Minneapolis & the Twin Cities Metro

Locally owned. Same-day response across the metro, no out-of-state subcontractors, ever.

FAQ

Common questions, straight answers

Do finished basements in Fulton need mold removal if the stain is small?+

Sometimes, yes. In Fulton, a small stain behind a baseboard can mean months of 60 to 70 percent humidity against older block or concrete. We check moisture levels first, then decide if cleaning, drywall removal, or better dehumidification is needed.

Can you inspect attic mold from ice dams near dormers?+

Yes. We inspect gables, dormer walls, lower roof edges, insulation, and attic ventilation. Fulton Tudors often have tight roof pockets where ice-dam leaks show up as dark roof sheathing before they show as a ceiling stain.

Will mold removal damage original trim or plaster in my Fulton home?+

Our goal is to remove only what the moisture and mold damage require. In 1930s to 1950s homes, we take extra care around plaster, baseboards, built-ins, and finished basement walls. If a clean cut can save good material, we will tell you that.

Is the inspection free for mold removal in Fulton Minneapolis?+

Yes, the inspection is free in Fulton. We look at the basement or attic, take moisture readings where needed, and explain the likely source, whether that is basement humidity, an ice-dam leak, or a venting problem.

We work the whole Twin Cities metro. Wherever you are, the job usually starts with a mold inspection and moves into removal and remediation. Curious about price? See Minneapolis mold removal cost. City-side, try a neighborhood page like Nokomis. Or a specialty scope like attic mold from a roof leak.

Browse the site

Everything we cover for Minneapolis homeowners

Pricing by job type, neighborhood-specific pages, and specialty scopes. Pick what looks like your situation.

Pricing

2026 Minneapolis mold pricing guides

Neighborhoods

Minneapolis neighborhood mold removal

Specialty jobs

Specialty mold services in Minneapolis

Mold won't wait. Neither do we.

Call now for a free inspection. A certified Minneapolis technician will be at your door, often the same day.

(612) 555-0142 Request a quote